Overview


The Signature Series SIGA-PCD detector brings advanced multi
sensor technology to a practical design that increases efficiency,
saves installation time, cuts costs, and extends life safety and
property protection capabilities. Continuous self-diagnostics en
sures reliability over the long-haul, while environmental compensa
tion helps reduce maintenance costs.
The SIGA-PCD provides a combination of optical detection for
the early detection of smoke, with the added element of carbon
monoxide sensing. The result is a detector that pulls double duty:
continually monitoring the environment for signs of fire — as well
as its invisible yet deadly companion: carbon monoxide.
Like all Signature Series detectors, the SIGA-PCD gathers analog
information from its sensing elements and converts this data into
digital signals. To make an alarm decision, the detector’s on-board
microprocessor measures and analyzes smoke sensor readings
and compares this information to historical data. Digital filters re
move signal patterns that are not typical of fires, thus virtually elimi
nating unwanted alarms. The detector also analyzes the smoke
sensor independently from the CO sensor to determine whether to
initiate a fire alarm, a life safety CO alarm, or both.
Standard Features
Note:
Some features described here may not be supported by
all control systems. Check your control panel’s Installation and
Operation Guide for details.
•
Next Generation Detection Technology
•
Integrates optical smoke with carbon monoxide detection
•
Wide 0.53 to 3.94 %/ft. (1.7 to 12.35 %/m) smoke obscuration
•
Sensor Markings Provide Easy Testing Identification
•
Uses existing wiring
•
Automatic device mapping
•
Ground fault detection by module
•
Up To 250 Total Signature Addresses Per Loop
•
Two levels of environmental compensation
•
Two levels of dirty detector warning
•
Twenty pre-alarm settings
•
Five sensitivity settings
•
Non-volatile memory
•
Electronic addressing
•
Environmental compensation
•
Automatic day/night sensitivity adjustment
•
Bicolor (green/red) status LED
•
Standard, relay, fault isolator, and audible mounting bases